Allow the wall to dry for at least a day.Īpply primer to the wall and let it dry. Try to touch only the tips of the splatter and don’t press too hard or you will flatten out the texture pattern.Ĭlean up the tools and splatters with water. Smooth over the tops of the joint compound spatters with the knockdown blade or drywall knife using very light pressure. ![]() ![]() Allow 10 to 20 minutes for the joint compound to partially dry, depending on the temperature and humidity in your area. Spray the wall evenly, working in a back-and-forth pattern, until the entire wall is covered with the thinned joint compound. The joint compound needs to be thin enough to pass through the sprayer, but still thick enough to stick on the wall without sliding-about the consistency of pancake batter.įill the hopper with the thinned joint compound and attach the sprayer, air hose and compressor. Mix water, a cup at a time, into the joint compound using a mixing paddle attached to a power drill. Tape windows, outlets and anything else that you don’t want covered with joint compound.ĭump the joint compound into a larger bucket. Tape sections of newspaper along the edge of the ceiling where it meets the wall. Lay a sheet or tarp on the floor at the base of the wall to protect the flooring and carpeting from joint compound spatters. ![]() Remove or correct any protruding nails, screws or hardware. Run your hand over the wall and make sure there aren’t any nails, screws or other protrusions.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |